Disabling ECM and Lowering the Baud rate on Canon Fax B140, B120 & B115. Select ECM TX and select OFF to disable during sending. Using the Left and Right arrows navigate to RX Settings. Press Start/Copy t o access the settings under RX Settings. In the System Settings screen, press the 'Network Settings' button and make a note of the imageRUNNER's IP address. This address consists of four sets of digits separated by periods.
- ...and followed the IBM specifications for MFRTYPDMDL using *HPCOLORLJ. Where are the IBM specs located? I don't see the C5255 listed under the supported Canon printers. Tom
report - Tom, the closest I could get was Canon Color ImageRUNNER Advance iR-C5000 Series. I used *HPCOLORLJ for MFRTYPMDL and *HPJLDRV for the System Driver Program. The tech from Canon said to referenence C5051 which also fall under the C5000 Series.
report - This worked for me on a Canon C5051 and V5r4 iSeries box. Thanks!
report - Has anyone used a Canon MF4700 as an iSeries printer? This is for our Honduras location, and the available printer options were not exactly robust. So we have this printer, ethernet-connected, but so far have not been able to get the printer to process iSeries reports.
report - One very important setting is the remote printer port on either the device description or the remote outq description.
report - As a starting point in configuring or setting up new printers I usually start at this IBM page : http://www-01.ibm.com/support/docview.wss?uid=nas8N1019605
report - 10 pointsBadges:
report - I found the way you narrated the issue hereis excellent, and if you can explain the paper jam issue in hp printer, then itwill be nice of you. Although, I found a link of the same while browsing whereyou can resolve the issue through HPPrinter Customer Care Number +1-870-345-4464 where you will be assisted bythe expert technicians within no time.
report
To set a static IP address, follow these steps.
- From the Home screen, tap Setup (if Setup is not on the screen, swipe over to it and tap it).
- Tap Device Settings.
- Tap LAN settings.
- Tap Other settings.
- Tap TCP/IP settings.
- Tap IPv4.
- Tap Yes.
- Tap IP address.
- Tap Manual setup.
- On the Enter IP address screen, tap the first set of numbers (octet) and then tap the numbers for the IP address that you want to specify. Then, tap OK.
Do this for the remaining sets of numbers (octets) in the IP address. Tap OK. - Repeat these steps for the subnet mask.
- Repeat these steps for the default gateway.